- - PVC film;
- - sandpaper;
- - rags;
- - sponge;
- - putty;
- - spatula;
- - roll;
- - oil paint;
- - plaster (if necessary);
- - a plumb;
- - water and detergent;
- - a plumb;
- - scissors (options: a knife or razor blade).
Make sure that the wall surface on which you are going to stick vinyl film , perfectly smooth.It's pretty crafty stuff, and even small roughness underneath are well marked.In the presence of mounds on the wall it is necessary to align and apply a new layer of plaster.If the surface is in good cond
ition, simply remove it from the old decorative coating (wallpaper, paint, etc.) and Wash grease and other contaminants.
Walk on the wall with sandpaper and apply a layer of putty.Then prime the recommended level surface any oil paint, make sure the liquid.After the performed procedures allow the wall to dry thoroughly.
Prepare rolls of vinyl film - they must first hold in a dry place at a temperature of about 18 degrees.After 2 days, the material can be used for wall papering.Roll roll on the floor and make the cloth pattern.Then make a very neat cut sharp razor blade, a special knife or scissors.Do not forget to leave a small allowance to then adjust the polyvinyl chloride film to the plinth.Cut into desired number of panels, stack them one on top of another seamy side.
Remove the protective layer on the underside of vinyl film (only the top of the cut strip!).Adding vertical with a plumb line, begin to stick on the designated line film from the ceiling to the floor.Gently straighten the strip of vinyl cloth and move downwards and from the center to the left and right.Watch closely so that no formation of bubbles!Gluing film about a meter in the din, to clarify once again plummet, even if it hangs.Then remove the remaining protective layer and rep cloth.
Place the next strip vinyl to the previous lap (about a centimeter).The edge has to go to the side of the window to the joints is not too conspicuous.Note that the joint was not inside corners with overlap of at least 2 cm. The junction of the two vinyl panels must be possible to press more tightly to each other and properly aligned.If you notice on the adhesive strip vinyl bubbles - delete it and do it all over again.To your work has been successful, keep the room air temperature from +15 to +18 degrees.
moistened film to and position on okleevaemoy details.In the wet state of the film is easy to move and find the right location.Using a hair dryer, heat the vinyl and taking a squeegee produce vinyl smoothing from the center to the edges of the film and from top to bottom.
How to glue?Instructions Car stickers vinyl stickers.In general, the technology of gluing vinyl on the machine is similar to the technology of applying tint film on the glass.It is desirable to have the following tools small labels (eg on the hood) on a flat surface can be bonded at lower temperatures.2. To start with the place where going to stick vinyl stickers.
- PVC film on fabric and paper subbase and baseless