you need
  • - corner bath;
  • - Roulette;
  • - small capacity;
  • - putty;
  • - spatula;
  • - building square;
  • - wall tiles;
  • - brick or concrete blocks;
  • - mortar;
  • - silicone sealant;
  • - punch;
  • - flexible moldings.
Guide
1
Before starting the installation, you will be required to hold a series of preparatory work.Armed with a tape, perform the measurements of your bathroom and decide the location of the corner bath.
2
Then proceed to finish the walls, which will adjoin your new bath.Thoroughly clean them from the old coating.In a small container, spread putty and gently put it on the wall with a spatula, trying to align all the irregularities.As a rule, all angular bath made from a template and have the adjacent angle of 90 degrees.So do not forget during the w
ork, to maintain the right angle, a square measuring its construction.
3
finished leveling the surface of the wall, put on her tile and proceed to install the bath.This can be done in two ways: uploaded to the additional grounds on foot as well as on the legs and arms, which are included in the kit.It is recommended to use the first method of installation, as it is more reliable.Place the bath on the proposed location horizontally using a tape measure, measure the distance from the floor to the bottom of the bath.
4
When all the measurements carried out, clean bath and begin laying special foundations of brick or foam blocks.It should be slightly less than the previously measured height.To perform this procedure using cement.Wait until the solution hardens.It usually takes no more than 12 hours.If between the systems of sewerage and drainage baths are gaps, and close them with a silicone sealant.Set the bath in place, connect it to the sewage system and filled with water, check for leaks in the drain.
5
If the design of the bath provides an additional wall mounting, use the puncher.Upon completion of all work securely fasten the wall between the bathroom and the elastic moldings.