- * cartridge respirator breathing;
- * Brush;
- * epoxy enamel, consisting of hardener and 1-2 sets of bases;
- * color color scheme;
- * shlifinstrumenta;
- * detergent;
choosing the enamel in the store do not skimp.Better to take an expensive Finnish than our epoksin or epovin.For the first time take not 1, but 2 sets of + hardener base.And in future hedging.If you want to color your bath, get and Kohler.Remember that if your bathtub has been colored, you should not expect that to be able to cut off once the color of the old coating.
Preparation is degreasing baths, creating a rough coating to increase the contact are
a between the old and the new coating, enameling and vystoyki.
All plums and remove the pads from the bath.Be Only metal housing.Rinse the bath detergent for dishes.It must be absolutely free of grease.
Make bath rough.Rinse twice to degrease.Then treat it with a grinder or abrasive grinding wheel bar.If at the bottom or in other places there were chips and cracks, they should be removed shlifinstrumenta.Then go to the bottom of kordschetkoy to clean out all cracks long-term dirt and rust.The main criterion for proper treatment: the nail that you spend on enamel, non-slip and scratch the bath.Then again, double wash tub with detergent.It is better to take the "Toilet Duck", "Sanoks" or "Adrilan" and pour them a bath for half an hour.Then you are absolutely sure that the bath degreased.Any means of how to rinse with hot water.After drying, vacuum the bath to remove all dust.
Bath is ready to spray enamel.Spread newspaper on the floor, put a container of enamel.It pour both components and mix until smooth stick.You will need a wide stiff brush hammers finishing (at least 7 cm wide).
Dip the brush into the container and apply a thin layer of enamel on the edge of the perimeter of the bath, and then the sides.After the brush along the bottom, and blend enamel.By alternating vertical and horizontal movements, first apply a base coat of enamel on the entire bath.The second layer is applied similarly.Without waiting for the drying of the previous layer.Carefully treat all sides of the bath.
For the third layer, spread a second set of enamel and act similarly.Enamel should be spread evenly over the entire surface.Which can be determined by conducting a brush.If it slides all the same, it means that you have achieved the desired effect.Remains pour the enamel on the bottom and flatten.
After 15 minutes, remove streaks as follows: a brush to smear the bottom up.Then look in the bath a few times until the enamel is no longer leaking.
Close bath for 4 days.After that it can be used.
complexity of self-restoration of the bath is that an ordinary person with such materials in his life never met, and therefore anticipate the result of their actions will be difficult.Therefore we advise you to practice on a small enamel basins, to get the hand.At the same repair bath you will take at least 7 hours.
When mixing hardener and the assets of the foundations of not more than 45 minutes, after which time it will be tight and will lay down smoothly.Therefore, the composition of plant needed after full preparation for the application of the enamel bath.