reasons on which it is necessary to replace the batteries in the winter, can be different.It is possible that there was an accident, replace the term can not be transferred before the end of the heating season, then it is necessary to do the job immediately.Replacing heater, setting screen, or other dismantling and installation work can be carried out in these cases is unimpeded. For example, heating devices, have worked for more than twenty years, can not fully carry out their functions to heat the room, so be replaced.

To disable heating to replace the battery



Installation of a new heat sink is performed only when disconnected risers heating networks.It is necessary to put notify the organization, serving the house, and invite its representative to override water standpipes.A short
, no more than three hours off the risers heating in winter is a paid service management companies.

In accordance with applicable regulations, their trip can not be done during the implementation of preventive measures in the heating system during test runs at low outdoor temperatures.The last requirement is particularly important during the cold season, when the outdoor temperature is set below -10 degrees C. To turn off the riser selected the warmest day so as not to cool the entire house.All work must be carried out (only employees of a specialized organization) very quickly, subject to a number of operational and technical requirements.

Some requirements while working



fact that the heating system in the winter is in operation, will allow to immediately assess the quality and effectiveness of the work done.The replacement should be carried out alternately, when the apartment is not disabled all radiators, but only one of them.After he started to work, it is the turn of the next.The installation of a battery can run for one hour, but for this (previously) should be performed measurements, prepared all the tools and accessories. order that there was no loss of heat and their own health, do not pay extra money for heating housing, the battery must be properly set.

In addition, we must remember that the radiator is mounted in compliance with the horizontal position, thus it should be parallel to the wall.It is mounted on three brackets, one of which is at the bottom, and two - top, they will form the main load.In the case of a large number of battery sections (greater than 12), the top of the wall (further) fixed one bracket.It is necessary to keep the distance between the top and bottom sill battery, it should not be less than 10 cm, otherwise the air curtain at the window will be weak.

representative service organization (after completion of all works) shall include the heating system risers.You should check the tightness of joints to avoid leaks in the pipe connections, shut-off and control valves.