- - bucket;
- - cloth;
- - pliers or pipe wrench;
- - set of wrenches;
- - thick board (40 mm);
- - simple pencil;
- - drill (the thinnest);
- - screws (socket head wrench);
- - screwdriver or a screwdriver;
- - rubber gaskets on the bolts;
- - cement solution with sand.
Shut off the water in the bathroom.Remove the excess water in the toilet cistern and using buckets and rags.Be sure to enclose a rag in the event of leakage in the process of dismantling the old plumbing.
Loosen the nut that connects the cistern with water supply line.It is located at the bottom left.Use the pliers or pipe wrench of appropriate size.
planks (about 40 mm) Grout in the recess under the base of the toilet.
Schedule pencil place engages the mounting holes where the
base of the board.Drill holes - Drill to be the thinnest.Install the toilet seat - insert the screws in the prepared holes, and screw the toilet to the board, which is concreted into the floor.
Lay the two rubber pads (they should be screwed) on the mounting holes that are on top of the installed toilets.It is necessary to check the location of the bolt heads - they must be on the inside of the tank.
Install cistern on the toilet bowl.Holes and bolts must be aligned.Tighten them with a wrench.Check for leaks: fill the water tank and around the bolts at the bottom of the cup, running his hand.If palpable space between the wall and the back of the tank, place a solid rubber or bar.
Connect with toilet sewage pipes.Seal with cement mortar or sealant joints.
The cistern adjust the float - it has to be above the level of control of the water overflow.
Before working, check whether the water is covered, in the bathroom, wipe the toilet seat after removing all dry, so that when working with power tools avoid short-circuiting.
to drill in a place not crumbled tiles (if you lay the tile in the bathroom), it is necessary to disconnect from the impact drill function.But included in the moment when the drill bit will pass through the liner.