you need
  • - or hammer drill;
  • - wrench and a gas;
  • - pencil and tape measure;
  • - a small amount of hemp;
  • - tee;
  • - flexible hoses 2 pieces of desired size.
Guide
1
To install the water heater, you need to pull out the water heater from the packaging, put up vertically knockouts for ease of preparation and pre-installation measurements.
2
make an inspection, refer to the instructions for use and installation.
3
Tighten the screws and level of support in order to avoid distortions in the operation of the heater.
4
The spirit level or plumb line, standing on the floor heater, set vertically.
5
Loosen the screws fixing supports small hammer to precipitate towards the top cover, so you can choose the backlash.Check horizontal support level, if it is necessary to a
lign and tighten the screws.
6
Select a location for the heater, taking into account the requirements of the operating instructions.
7
pay attention to the issue of connecting the water heater to the network of electric current:
Meals should be from a single source, without extension;

-Must be provided grounding.
8
Make markup installation location, taking into account the size of the water heater.
9
make a hole in the wall for fixing anchors, depending on the material of the walls, select a tool for drilling holes.
10
Set the water heater should be prepared at the site of attachment.
11
Cold water connection:
-after cold water meters put the tee;

-from supplied water heater install a safety-relief valve;

-k him to connect the hose and a second end to the water heater, the exit is blue;

-connection to do with thread reeling rags or other material.
12
Connecting hot water:
-after counter hot water to install a tee;

-Connect hose right size;

-second end of the hose connected to the water heater;

-with connections make reeling tow on the threads.
13
Install supplied drain valve to release excess pressure.
14
After installation of the heater, you must turn on the cold water with the hot water tap open in a mixer.Make sure that when water flows from the tap, so the water heater tank is filled with water and the device is ready for use.