hot water meters must be installed so that you can at any time withdraw his testimony, and also to make running repairs.If you want to shut down the counter from prying eyes, do it so that a mechanic in the future could easily remove the overlay.Among other things, will have to leave access to the filter cleaning as the need to change periodically.Try to think in advance the location counter to further his replacement did not require a violation you have made repairs.
counter must only be installed horizontally so that it sealed the and allowed to operate.To start, you need to replace the inlet valve is responsible for the water supply.Be sure to pay attention to the condition of the Box and what turns you will need to do to wind the faucet.The ideal is to make at least 4 turns to wind the crane wi
Screw tap on the sidebar, and then screw the valve on the strainer.With the filter must be handled very carefully, otherwise it will not be able to pass water.Then you need to wind filter with flax three turns, then screw in the brass fitting and a nut, and the second you need to screw the nozzle check valve.You must then insert the rubber or silicone gaskets in the union, and pay attention to where the arrow points to the direction of the water.If this arrow is not present, you can navigate to the grid, which is placed on the input side of the water.
Now we need to tie himself to the counter nuts on the fittings.As a result, you should have a structure "Box - valve - strainer - counter - return valve."The easiest way to install the counter, if the water in your home is made of polypropylene.In the case of iron pipes have to create additional structures made of tubes and brass corners that require you additional knowledge and skills.
If you do not have time to install the meter, you can entrust this work to a specialist.It will set the counter only for a certain amount, and the better to reach an agreement with him to buy all the necessary materials.
Tip 2: How to install the counter hot water
Utility bills for water collected from the population can be divided into two groups: the payment of actual consumption water and fees for each prescribed in the apartment tenant.In the latter case, the rate set by the state, which is supposed to use the average citizen per month.If you want to pay for actual consumption of hot and cold water, you will need to purchase counter .
Installation of meters is carried out at the expense of the employer or of the owner or a special organization.The basis of the project will be developed by the project organization and consistent with the management company.
To install water meters, you must have a good support fittings and straight pipe, which is located after the valve should be not less than thirty centimeters.Sami pipe must be metal.
Do not forget that the organization, which will help you to install water meters shall provide the following documents: If the meter was not purchased by the owner, the passport of the device, as well as a contract for services.
After all counters are installed, they must be sealed.To do this, refer to the management company.
owners who installed the counters, each month will have to record all receipts in the testimony water meters, and then to pay the accrued payments for services rendered water.Calculations are made on the tariffs set in the approved manner.
The passport of the water meter will indicate the requirement that establishes the procedure for regular inspection of meters.Usually it depends on the model of the device, but in general, they are tested at least once in 5-6 years.