Guide
1
necessary to use boiled water.But if a small section of pipe, and ice has accumulated 20 meters from the exit pipe , manually implement such ideas fail.In this case the need to carry out some action.
2
Find rigid plastic pipes (no hose) with an outer diameter that is slightly smaller than the inner diameter of the tap, Kojima finishes available to you tube station .
3
Get stolitrovuyu barrel and pump.Feeding hot water through a funnel - not an option.If you do not know how to mechanize the process, you can spend a lot of time.
4
Fill barrel of 100 liters of bo
iling water, and continuously heated.
5
Now you are ready to get rid of ice in the pipe.Shove it in a tube, through which the hot water will flow.Then turn on the pump that will pump hot water into the tube.After a few seconds, you probably already can push the pipe with boiling water a little further.Although the ice, you still will be rested.
6
In this case you need to put a bucket under the faucet to turn on after a few cycles of the pump you could dial it in a bucket of clean and hot water is poured back and pour it into a barrel.That is, your next steps are as follows: You substitute a bucket and wait until it is filled.Then you turn off the pump, fill with water from a bucket into the barrel, put a bucket under the faucet and then turn on the pump.Do not forget to periodically push the pipe with boiling water forward until it stops.
7
Be prepared for the fact that from tube with a pressure water will rush after you pierce the ice cap.In this case, you should quickly pull the tube and close the valve.