you need
  • electric drill, electric jig saw, clamps, pliers, screwdriver, screwdriver, tape measure, pencil, sharp knife, ruler, clean rags, sealant
Guide
1
Preparethe tools necessary to install a sink.You will need a drill, an electric jigsaw, clamps, pliers, screwdriver, screwdriver, tape measure, pencil, sharp knife, ruler, clean rags, sealant.Some models are equipped with special sink template facilitates the process of marking the holes for the installation.
2
Remove the countertop from the table and place it comfortably.Start by marking the contour surface cleaning countertops.If there is a pattern, draw around it with a pencil.In the absence of a template to attach the
sink counter top and mark its outline with the trace must be strictly on the edge of the sink.Then depart from the resulting line into 1-1.5 cm and spend another smaller circuit (this circuit will work).
3
Proceed to the cutting out of the hole.First drill drill four holes with a diameter of 10 mm at each end of the working circuit.These holes will be needed for the jigsaw.Insert the fabric jigsaw into the hole and secure it in the instrument.Carefully cut along the contour of the hole jigsaw.
4
Clean sectioning of dust and sawdust.Then treat the cut sealant that does not allow water to penetrate the material.The sealant should be applied with a spatula or a brush, trying to apply an even layer of the material.Sealants can serve as epoxy or silicone.For wooden or plastic table top sealers suitable alcohol.
5
After drying sealant attach the countertop to the cabinet and secure it.Before installing the immediate washing grease the edges on the back side with silicone or glue on the edge of the pad.
6
Then, place the sink in the countertop opening and push through the clamps prepared in advance.Leave the structure for some time that sealants can be stabilized.Then carefully remove the excess sealant or silicone.Cleaning ready for use.It remains to be mounted on the sink faucet and connect the liner of water.