you need
  • - towel;
  • - Teflon tape;
  • - Screwdriver;
  • - pliers;
  • - a guarantee or form of maintenance.
Guide
1
Check for leakage water hose.This is one of the most common causes of failure washing machines Samsung.Use an old towel for hands to tie pipes for hot and cold water to the point where just about to begin to leak water.To replace a leaky hose, disconnect the water supply to the washing machine .Unscrew the old hose and pipe wrap Teflon tape.Attach the new hose and turn the water supply back.
2
Check hose ends hot and cold water to make sure it is done properly feed.If you see that at the end of the hose leaks, turn off the water, and then unscrew it.Inspect the
washer on the inside for cracks or other damage.Replace the washer, if necessary, and then wrap the pipe with Teflon tape, re-attach the hose and turn on water supply.
3
Check hoses that run from the bath to drain pump for cracks and other damage.If any of them is damaged, use a pair of pliers to pull the hose out of the metal springs, and replace it with a new one.
4
Unplug the washing machine from the network, turn off the water supply and turn the device.Use a screwdriver to remove the plate on the rear panel.Inspect the inside of the equipment, check the attachment of the drum, remove the remnants of dust, dirt and grime, if they are available.
5
Run the washing machine, check out how the water is dialed, if all functions are turned on and working properly.In the event of malfunctions in the electronic system of the device, store them in a piece of maintenance equipment attached to, and consult your nearest service center Samsung.If the equipment is under warranty, contact his supplier and get further instructions.