Tip 1: How to set the tap in the bath

Quite often people have to deal with installing or replacing tap in the bathroom.This case must be approached responsibly.If the installation crane be mistakes, he will continue to occur.
Guide
1
If your washbasin mixer fitted with the lower chamber displacement, in his shelf, make two additional holes.Their carefully layered punch narrow sharp chisel.Work on the start hole from the back side of the shelf.In this case, it will provide a more reliable stability washbasin.Also worth noting is that the chisel is less than the slide on the contours of the extruded holes.Before you get to work, get the hang of working with faience.
2
So get to work.To start, determine and mark the location of the bath.For this purpose, use a tape measure and a pencil.Next, you will need wooden blocks.They are necessary to create the drain water from the bath.Cut an opening in the floor, which is required for laying pipes below the floor bathroom.To do this, use the grinder.By doing so you will ensure good
drainage of water from the bath.
3
After this well entrenched bath on the floor.Then you need to make the promotion around the drain hole under the bath.To do this, use small pieces of wood.Secure them with nails.Then you can move on to the preparation of the wall.Use a hammer to remove the existing wall covering in the location crane soul.Include in this place faucet shower.Secure it with the studs.Please note during installation crane inside the construction can get a different litter.These particles will cause serious damage to the sealing crane and may cause water leakage.To remove it, open the water and let it run for 15 seconds.Move the valve to the "off".Make sure that all the specks of dust and debris removed.
4
sure to follow the installation of the control mechanism in the bath water drainage.Most often tap for shower and control mechanism available in the general package.Move the tube to drain water bath.

Tip 2: How to Install a Faucet

Sometimes you need to replace the faucet in the kitchen - if the old become worthless, or you just want to upgrade plumbing fixtures.The easiest way to buy a good mixer and bring home a professional plumber, but to set the tap is simple enough, and if you have the right tools, you can install a kitchen faucet yourself.
How to install the faucet
Guide
1
Take a pipe wrench, screwdriver set, sealing, special plumbing tape or tow, and of course, the faucet.Turn the valve and turn off the water.
2
Open an existing faucet and drain the water remaining in the pipe.Gas or adjustable wrench, unscrew the threaded pipe from the old crane, relax mount.
3
Turn the key mounted around the pipe in a clockwise direction to remove the retaining nut.Sprinkle on her special lube that the nut was easier.One key lock nut and unscrew the second coupling pipe.Remove the unscrewed pipe tap and disconnect the water supply hose.
4
Replace valves, following the direction of water flow indicated on the valve.Before installing the valve, put on the shelf a special cleaning pad, which will be under the twisted crane.Slide the faucet on the sink and tighten the nut, tightening it as much as possible.
5
tap Connect to pipes and valves with flexible hose and seal the joints with tape or plumbing hemp.With sealant and tighten all connections.
6
In conjunction with the tap pipe must be located sanitary napkin ring, preventing the flow of water.
7
Unscrew the valves and try to open the valve - check if the water is not flowing, and is firmly tightened all connections.At this point you know how to install the faucet in the kitchen.
609
0
1
Plumbing