should know that the washing machine should be installed on a firm, flat surface, such as a tiled floor in the bathroom or kitchen.If you put a car on a wooden floor, sag under her weight, her work will be accompanied by strong vibration, and eventually the machine will fail.
Most washing machines are equipped with adjustable feet that are located at each of the four corners on the bottom of the machine.Each leg is a screw connection with a support made of plastic or rubber.Rotate the prop in a clockwise direction, you will achieve the reduction of the height of the legs, rotating in the opposite side of the support will increase the height of the foot.
Put the washing machine to the place where it will be installed, and with the help of liquid
level, determine the degree of tilt of the machine in one direction or another.Rotating machine feet, adjust the position vertically and horizontally so that the level in any plane is zero.In some cases, screw supports feet rotate too hard for them to adjust should use a wrench bean type.
weight of any of the washing machine and big enough to put it on a level, it is best to attract mates.While one person will hold the machine tilted, adjust the height of the second leg.If the area of the room where the machine is located, allows you to get free access to all four legs, the work can be done alone.
Tip 2: How to put the washing machine on a level
very important factor for the correct installation of the washing machine is to install it right on level .When installed correctly, the machine will be stable, and therefore will not vibrate and make noise.
- - washing machine;
- - level;
- - assistant.
Ideally, the floor under the washing machine has to be concrete.On the wooden floor machine will vibrate strongly during the spin cycle and quickly fail.If a wood floor you have concrete, remove the board and fill the place in the washing machine to the level of the concrete floor.
Washing machine is equipped with four adjustable feet, which is essentially a screw connection with a support of rubber or plastic.Twisting clockwise support - you reduce the height of the foot, counterclockwise - lengthen it.It is not necessary to turn out the legs once the entire length, adjust their level of .Then the volume of noise at work will decrease, and the life of the machine will increase.
You perfectly leveled floor under the washing machine?Remarkably, it is much easier to install machines.Just tighten all legs as short as possible and put machine on a level floor.
Sex is not perfect?Use level.Put it in the washing machine diagonally, so you will understand - which side to adjust the leg.After alignment, place the level on the other diagonal.Twisting the legs, you will ensure a smooth and stable position of your car.
Washing machine - something heavy.Call Assistant while it will keep the car inclined, you adjust the height of the legs.Work alone only when a large area of the room and have free access to the car from all sides.
washing machine must stand on all feet.A common mistake when installing with the level - it shows the correct level, even if the floor concerned, only three of the four legs.
forbidden to touch the washing machine with walls and furniture.Do not use to compensate for irregularities different stand.If you do not level, take a deep dish, pour in the water and put it on the car.Adjust the length of the legs so that the distance from the surface to the edge of the plates on all sides was the same.
- how to adjust the
If you want to install the machine immediately, and you do not have liquid level, as a last resort can use the smartphone with the accelerometer.Install the gadget in one of the many applications that perform the function level that now exist for all popular platforms (iOS, Android, Symbian, Windows mobile).Run the application and use the device as a level.
Use only quality in liquid level, length of at least 300-400 mm.So you can put as precisely as possible the washing machine.Water or a laser level to set the washing machine is not suitable.