Tip 1: How to mount the door

interior door - an essential element in a home or apartment, allowing not only to share the room, to create comfort, but also to protect them from noise.To a beautiful door during operation does not bring you problems, you need to install it correctly.
Guide
1
Please make sure that all components and parts to install.Visually inspect the door and box quality.Upon detection of possible defects or the absence of any parts and components notify the Seller.If OK, perform measurements and prepare an opening for the installation of doors .
2
Install hinges on the door.The distance from both the top and bottom of the door before loops should be 20 cm. Mark the fastening loops pencil or awl.Drill holes with a thin drill, in order to avoid damage to the surface and fasten hinge screws.
3
Collect box.During installation, align the box vertically on a level to prevent random opening or closing the door tilted in one direction or another.Fix the box with screws at the position of the hin
ges.
4
Hang the door on the hinge side with a gap between the door and the frame of 1-1.5 mm.The same gap must be between the top bar of the box and the door and the lock side.
5
Fix the vertical riser.Place the pads of cardboard to fix a uniform gap between the door and frame.Paste over the surface of the door frame and the door masking tape to protect from the effects of the foam.
6
Apply foam between the opening and the door frame.The curing time is generally a foam from 4 hours to 1 day, depending on the area to be treated.
7
Remove the tape, cardboard pads and projecting excess foam.Check the clearance around the perimeter and the vestibule.Embed the door lock.
8
Install dampers for soft serve and less noisy closing doors.

Tip 2: How to mount the door

With the acquisition of liked the front door there is a most pressing issue related to its installation in the doorway.After all, the quality of its implementation depends on how it will meet its core functionality and whether to provide decent housing protection from intruders.Taking into account the above, the door to be mounted must be taken seriously.
How to mount the door
you need
  • - punch;
  • - set of drills;
  • - anchor screws - 8 pieces;
  • - screwdriver.
Guide
1
Any door frame is fixed in the opening by means of anchors that are required to be firmly embedded in the wall material.In concrete or masonry are laid at a depth of up to ten centimeters, silicate blocks or other porous structure with voids - 150-200 mm.
2
design anchors designed so that after tightening the bolt so it is securely attached to the wall, pull it is impossible without a piece of masonry.The most expensive of them are made of metal, which can not be cut disc angle grinder, but only the gas burner.
3
Settle anchor bolts in the wall of the doorway as follows: - two opposite loops on each side of the wall,
- one in the center;the sides, top and bottom.
4
Fixing the door frame in two ways (please specify when purchasing).
5
first involves breaching the required number of punch holes in the wall opening, in which anchors are inserted later.Then they are threaded bolts in the brackets, and the whole structure is fixed by tightening the screws with a screwdriver.Box with door is attached to the built-in mounting elements.
6
second method is carried out somewhat differently.Initially, the door is exposed on the construction level in the doorway.If required under the bottom of the box to pour the required volume of concrete or grout.Then it is done one by one top and bottom holes through the door frame in the masonry wall.They are inserted and tightened anchor bolts.After fixing the door similarly inserted, and the remaining six mounting units, three on each side of the box.
7
Once the door is installed in the wall opening, it is on the perimeter of the building blown foam, and then closed up the slopes.
137
0
1
Security Systems