you need
  • -rozetka grounding of 16 Amps
  • -provodka with a cross section of 1.5 mm
  • -kran for three quarters of an inch
  • feed for FCMs
  • -razvodnoy double tee or on the water
  • -razvodnoy tee to drain or siphon with drainage
  • -level
Guide
1
Each machine has a guarantee that an incorrect installation and connection is removed.Therefore, if you are not sure that everything can be done in accordance with installation rules, invite experts.For a modest fee you hold all installation work with quality assurance.If you at least once connected the self-washing machine-automatic , then connecting the built-in dishwasher is easy to manage.Because the principle is exactly the same.
2
Place the machine in the intended niche.Align the legs, draw level and leveling feet locknuts secure.
3
Install the mains outlet at a distance from the wire to the machine can reach it easily.The outlet must be 16 amperes.
4
Spend on the electrical panel wiring to a separate outlet.The cross section of the wiring must be between 1.5 mm and above.
5
Make sidebar in the water and set the valve threaded three-quarters of an inch.If the car is provided to connect to the hot water supply valve must be installed on the hot water.Although experts do not recommend to connect the extremely hot water because the quality is poor and the machine can quickly be damaged.But up to you.Screw the hose from the dishwasher to the faucet.If you connect additional appliances that require power from the water supply, install an adjustable double or tee and connect to it all the necessary equipment.
6
to the sewage system can be connected by an adjustable double or tee, as well as to the siphon with drainage valve and reverse.In this case, you need to focus on what is already installed or that still need to be connected.
7
Secure the countertop.Install the facade with the cap screws.Depending on the model of the facade can be adjusted with the help of a strong or weak tightening fasteners.
8
first launch of the machine should be without utensils on the shortest mode.Check all connections and if there is a leak, tighten all.