you need
  • one of the cross-shaped screwdrivers;
  • flat screwdriver;
  • spanner 19;
  • wrench 8/9;
  • cleat clamps pliers, wire cutters;
  • simple wire cutters;
  • pliers;
  • bent long pliers.
If you decide to do this procedure on their own, without resorting to the services of professional masters, you need to adhere to the following algorithm of actions.First, remove the top panel of the washing
machine with one of the cross-shaped screwdriver.Then, remove the screws that connect the panel to the housing.Lift the left hand rear part of the panel, slide the right hand front machine backwards.
one hand, lift the back of the panel, and then slide the top panel with the other hand in the direction of the rear wall before it will be disengaged.
Remove the control panel of the washing machine.To do this, pull out the detergent dispenser, a Phillips screwdriver, unscrew the distributor box, hold firmly the control panel with one hand and with the other hand slide it out at an angle of approximately 90 degrees to disengage the panel.In this position, turn the panel parallel to the side wall of the washing machine at an angle of 180 degrees.With hook lock the service panel on the side wall of the machine .
Proceed to dismantle the service panel.Use a screwdriver to unscrew the two screws that connect it to the side walls of the washing machine .Wooden or plastic crowbar unhook the bottom panel.Open the door of the washing machine clamp and remove the cuffs from his door, then remove the collar itself.
Remove the central panel of a washing machine .Remove the four screws holding it to the side walls of the machine .Remove the central panel and disconnect the connector lock the hatch, and then - on the tank drain hoses, front counterweight.
Remove the screws and separate the tank into two halves.Remove the two screws and slide the cover machine and remove the V-belt pulley.
Turn off fixing nuts and remove a pulley, then remove the drum washing machines .All operations must be done with utmost care.