Tip 1: How to replace the drain hose in the washing machine

When the washing machine is working, no one thinks about the important function it performs.But should something go wrong, as the start global catastrophe.Even such a trifle as the drain hose able to withdraw from the usual mode of life of the bed.Just accumulate mountains of laundry, and the problem of breakage, we have to be addressed urgently.Fortunately, the drain hose can be easily replaced independently, without resorting to the services of the master.
you need
  • - the new drain hose;
  • - screwdriver.
Guide
1
have any model of the washing machine drain hose is attached inside the body near the pump for pumping water.It comes out on the rear wall above or below the housing, depending on the model of the machine.
2
most models to get to the base, which is attached drain hose, you need to remove the front panel.When removing the rear wall of the drum will hinder the work.Before the repair, turn off the power, close the valves controlling water supply, pull out the end of the ho
se attachment of the sewer.
3
To remove the front wall, remove the dispenser powder and the air conditioner, remove the attachment of the front wall and the control panel.Remove the cover of the pump, drain the remaining water in a special container.Remove the wires from the hatch, put all the parts removed to the side.
4
To remove the drain hose is damaged, remove the clamp.Undo the attachment to the body and pull the hose through the back wall, as through the front open space do not succeed because of the fact that the end of the hose that is attached to the sewage system, is much thicker than the hole through which it passes to the mounting system.
5
For this reason, the new hose will have to insert from the rear wall and weed out ahead.First, insert the hose on the mount, tighten the clamp and only then attach the hose to the wall mount.Connect the replaced hose to the sewage system, install the panel, fasten bolts, put the front wall and a powder dispenser.
6
Turn the washing machine.Set the rinse.Check attachment for leaks.If the collar is screwed badly, it would have to remove and tighten all fasteners.So try everything at once tighten securely to avoid doing the same job several times.

Tip 2: How to replace the drain hose

Broken washing machine for each is a serious problem and requires a challenge to master.In some cases, you can manually identify and eliminate breakage.If the damage of the drain hose washing machine to replace it you need to access the inside of her body.Corrugated drain hose is mounted inside the machine, near the drain pump.It passes through the wall of the housing and out through a rear wall, top or bottom.
Guide
1
principle of replacing the drain hose identical in most washing machines.For example, to replace the drain hose on the machine AEG, Bosch and Siemens, first remove the front wall, as to get close to securing the drain hose from these washing machines is only possible in this way.
2
To do this, remove the clamp and remove the sleeve from the front wall of the hatch.Carefully remove the dispenser.
Remove the decorative panel in the basement part.Drain the excess water through the filter pump.It is enough to put a cloth under it.Remove the screws secures the front wall to the cabinet of the washing machine.
3
front wall is secured by three screws, one of which is at the top, and two - on the bottom.Take a bit of the lower part of the wall, slide it down and disconnect the 5-7 cm entire wall.Disconnect the lock of the hatch that is at the wall.
4
now gaining access to the inside of the washing machine, you can begin to replace most of the drain hose .To do this, remove the clamp from the mounting of the drain hose and disconnect the hose from the drain system.Try to remember the hose attachment points .Unplug it from the wall housing and Output.
5
Insert the new hose into place and tighten the fixing old his collar.Pass the hose on the wall, making it mounted to the chassis, and Output.To connect the sewerage system lead-out end hose and check for leaks both ends.Assemble the front wall in the reverse order.
6
replace the drain hose washing machines Ariston, Indesit, Ardo, Samsung, Beko, LG, Candy, Whirpool can be accessed via the bottom;Electrolux and Zanussi - through the back wall;vertical washing machine is sufficient to remove the side wall.
Sources:
  • how to install the drain hose
707
0
0
Plumbing