- - hardened steel wire with a diameter of 2-4 mm;
- - Construction gidrouroven (max);
- - mug douches (enema);
- - electrical tape;
- - hot water
- - bucket;
- - wire cutters;
- - two-wire copper wire;
- - plug for the power socket;
- - pump or compressor;
- - hose;
- - rigid plastic tube with a tap at one end;
- - barrel per hundred liters;
- - 100 liters of boiling water;
- - boiler.
Align steel wire.Expand gidrouroven.The end of the steel wire loop wrap.Using tape, attach the loop to the end of the tube gidrourovnya, but this should be done so that the head level advocated by about one centimeter.Then fasten the wire with electrical tape and level along the entire length.The second end gidrourovnya attach to the mug Esma
rch.Steel wire tied gidrourovnya propihnite tube into a plastic pipe with frozen water.Push through as long as you hit the ice.With the help of an enema enter hot water and as melting "plug" push wire deep into plastic pipe.Place a bucket under the pipe end, as much as you enter the hot water, the same amount of cold water will pour out from the pipeline.
Remove the insulation from copper wire.Then remove the insulation from a wire, and the second is in isolation, neatly bend in the opposite direction.At one end of the wire wrap bare wire five turns.Wrap so that the coils tightly arranged next to each groomsman.Using wire cutters Bite once stripped wire end.From the end turns back down about three millimeters and the second bare wire winding it as well as wound for the first time.At the other end of the copper wire attach plug.This results in a device which is popularly known as "Burbulyator."Puts a copper wire in a plastic tube up until you hit the ice, including "Burbulyator" in the socket and a bit of wire propihnite pipe (need to bare end of the instrument is at the very "plug").When you feel that the wire "falls" into the pipe , push through it further.After about a meter unfreeze "plug" by means of a compressor pump out water and continue to defrost on.
Stick plastic pipe plastic plumbing in stasis so that the end with the tap turned out.Turn on the pump and pump the hot water through a plastic pipe used in plumbing.Place a bucket under the faucet pipe and grind off the chilled water (you can boil, pour into the barrel and use the water is pumped in to defrost "plug").Continue to defrost water to the disappearance of the "plug", alternating with the hot water supply and discharge of warm water.
including "Burbulyator" in the socket, follow the basic rules of electrical safety!
If there is no desire on their own warm water in plastic water pipe network can take advantage of special services involved defrost pipes.
- How to unfreeze water pipes.